| General | |
|---|---|
| Chipping Capacity | 9 in. |
Power take offs on utility tractors have become a primary source for much of the work around farms, orchards, golf courses, etc. Any place where you need to turn a pile of branches into a pile of chips. You choose - self feed or hydrostatic hydraulic feed for infinite feed settings - these chippers mount on your three point hitch and hook directly to the PTO for quick setup and power on demand.
Rotating 360 degrees, the 8 inch round discharge chute gives you accurate control over the flow of chips produced. The 30 x 1 inch thick, 275 pound dynamically-balanced disc, adjustable 4-sided anvil, four reversible chipper blades. The feed roller on the CH9540H is 15 inches in diameter, containing 10 knife blades for enhanced powerful feeding. A hydraulic jack is mounted on the hydraulic feed system for ease of maintenance. Plate steel construction means solid performance for hundreds of hours, and maintenance is enhanced by a hinged disc cover that provides wide open access to the chipper blades and disc..
- Chipper Capacity (in): 9
- L x W x H (in): 70 x 50 x 93
- Weight (lbs): 1300
- Chipper Disc: 30 x 1.25/275 lbs., rotates at 1,500 rpm
- Ideal Acreage: PTO
- Feed Opening: 9 x 9
Chipper/Shredder
- Chipper Chute Opening (in): 30 x 31
- Chipper Blades: 4 reversible heat treated steel chipper blades with 4 sided adjustable anvil
- Rotor Weight (lbs): 275
- Discharge: Overhead
- Drive Belt: Triple-Banded
- PTO HP Required: 35-60 HP
- PTO Capable: Yes
- Blade Kit 74830-00
- Chipper Low Profile Side Discharge
- Fine Chip Rotor Kit
- Consumer: 3 Year
- Commercial: 1 Year
- Rental: 6 Month